Spicer S44/3R Rear U-Joint Kit - 2007 Chevy Silverado 1500 Classic 2WD - 157.5-in WB, LS, 2-pc rear shaft

For the rear driveshaft on 2007 Chevy Silverado 1500 Classic 2WD.
This is a limited listed-parts bundle. Match the complete vehicle and shaft conditions below before ordering.
Required configuration (2007):
Trim: LS; Drive: RWD; Wheelbase (in): 157.5; Wheelbase (cm): 400.1.
- Rear Driveshaft at Rear Axle: 1 x Spicer 5-3147X - Inside Snap Ring Dimension of 2.556in; with 2 Piece Rear Driveshaft; 1.125in Bearing Cap Diameter; Greaseable.
- Rear Driveshaft at Support Bearing: 1 x Spicer 5-3147X - Inside Snap Ring Dimension of 2.556in; with 2 Piece Rear Driveshaft; 1.125in Bearing Cap Diameter; Greaseable.
- Rear Driveshaft at Transmission: 1 x Spicer 5-3147X - Inside Snap Ring Dimension of 2.556in; with 2 Piece Rear Driveshaft; 1.125in Bearing Cap Diameter; Greaseable.

Includes: 3 x Spicer 5-3147X.

Measure before ordering:
5-3147X: 1.125-inch (28.575 mm) bearing caps on both axes; 2.556-inch (64.922 mm) inside snap-ring span (NOT overall width) on both axes. Inside snap rings (ISR). Greaseable.
Use a caliper to measure every cap and BOTH joint axes. Measure the inside snap-ring span, not the overall cap-to-cap width.

Only the listed parts are included. This is not a complete driveshaft or CV rebuild kit; unlisted centering parts, yokes and separate installation hardware are not included. Verify modified shafts individually.