Spicer 1410 Rear Carrier & U-Joint Kit - 2000–2002 Dodge Ram 3500 RWD - 8.0L, 10-cyl, Cab & Chassis, Auto, 4-speed, 2-pc rear shaft, 1410 shaft

For the rear driveshaft on 2000–2002 Dodge Ram 3500 RWD.
This is a limited listed-parts bundle. Match the complete vehicle and shaft conditions below before ordering.
Required configuration (2000, 2001, 2002):
Engine (L): 8.0; Cylinders: 10; Engine layout: V; C C: 7990; C I D: 488; Engine Bore Inches: 4.00; Engine Bore Metric: 101.6; Engine Stroke Inches: 3.88; Engine Stroke Metric: 98.6; Body/cab: Cab & Chassis; Drive: RWD; Transmission speeds: 4; Transmission: Automatic.
- Center support bearing: 1 x Spicer 211848-1X - with Standard Mounting Threads; with Standard Threads; Replaces OE Part Number(s) 04773014.
- Rear Driveshaft at Rear Axle: 1 x Spicer 5-160X - with 1410 Series Driveshaft; with 2 Piece Rear Driveshaft; with Cap to Cap Dimension 4.188in; with Outside Snap Rings; 1.188in Bearing Cap Diameter; Greaseable; with 4.188in Outside Snap Ring Dimension; with Cap Diameter 1.188in.
- Rear Driveshaft at Support Bearing: 1 x Spicer 5-160X - with 1410 Series Driveshaft; with 2 Piece Rear Driveshaft; with Cap to Cap Dimension 4.188in; with Outside Snap Rings; 1.188in Bearing Cap Diameter; Greaseable; with 4.188in Outside Snap Ring Dimension; with Cap Diameter 1.188in.
- Rear Driveshaft at Transmission: 1 x Spicer 5-160X - with 1410 Series Driveshaft; with 2 Piece Rear Driveshaft; with Cap to Cap Dimension 4.188in; with Outside Snap Rings; 1.188in Bearing Cap Diameter; Greaseable; with 4.188in Outside Snap Ring Dimension; with Cap Diameter 1.188in.

Includes: 1 x Spicer 211848-1X, 3 x Spicer 5-160X.

Measure before ordering:
211848-1X: 1.574-inch bearing bore/inside diameter. Mounting centers 3.380 inches; bracket width (front-to-back) 1.500 inches; bearing centerline to mounting surface 3.250 inches. 7/16-14 threaded nuts incorporated into bracket; no studs included. Current page reports 0.437 × 14.000 thread and 0.437-inch bolt-hole field.
5-160X: 1.188-inch (30.175 mm) bearing caps on both axes; 4.188-inch (106.4 mm) overall cap-to-cap width on both axes. Outside snap rings (OSR). Greaseable.
Use a caliper to measure every cap and BOTH joint axes. Compress the caps and measure the overall width across opposing cap end faces.
For the bearing, check the shaft bearing seat/bore and the actual mounting arrangement. Mounting centers are not overall bracket length; center height is measured to the mounting surface.

Only the listed parts are included. This is not a complete driveshaft or CV rebuild kit; unlisted centering parts, yokes and separate installation hardware are not included. Verify modified shafts individually.