Spicer 1480 Rear Carrier & U-Joint Kit - 2005–2006 Chevy Silverado 2500 HD 2WD - Crew Cab, 167.0-in WB, Spicer shaft, 1480 shaft
Spicer 1480 Rear Carrier & U-Joint Kit - 2005–2006 Chevy Silverado 2500 HD 2WD - Crew Cab, 167.0-in WB, Spicer shaft, 1480 shaft
Couldn't load pickup availability
Free shipping in the continental USA. Ships same day via UPS if ordered by 12pm M/F. 30-day returns on unused items in original packaging (sale items excluded). Questions: sales@platinumperformanceparts.com
For the rear driveshaft on 2005–2006 Chevy Silverado 2500 HD 2WD.
This is a limited listed-parts bundle. Match the complete vehicle and shaft conditions below before ordering.
Required configuration (2005, 2006):
Body/cab: Crew Cab Pickup; Drive: RWD; Wheelbase (in): 167.0; Wheelbase (cm): 424.2.
- Center support bearing: 1 x Spicer 212028-1X - Replaces OE Part Number(s) 88934865.
- Rear Driveshaft at Rear Axle: 1 x Spicer 5-188X - with 4.188in Outside Snap Ring Dimension; with Spicer 1480 Series Driveshaft; 1.375in Bearing Cap Diameter; Greaseable.
- Rear Driveshaft at Support Bearing: 1 x Spicer 5-188X - with 4.188in Outside Snap Ring Dimension; with Spicer 1480 Series Driveshaft; 1.375in Bearing Cap Diameter; Greaseable.
- Rear Driveshaft at Transmission: 1 x Spicer 5-188X - with 4.188in Outside Snap Ring Dimension; with Spicer 1480 Series Driveshaft; 1.375in Bearing Cap Diameter; Greaseable.
Includes: 1 x Spicer 212028-1X, 3 x Spicer 5-188X.
Measure before ordering:
212028-1X: 1.574-inch bearing bore/inside diameter. Mounting centers 6.620 inches; bracket width (front-to-back) 1.500 inches; bearing centerline to mounting surface 2.250 inches. M10 × 1.5 mounting studs, shown in official Style 17 diagram. Current page lists 0.394-inch bolt-hole field and M10 × 1.5 stud thread.
5-188X: 1.375-inch (34.9 mm) bearing caps on both axes; 4.188-inch (106.4 mm) overall cap-to-cap width on both axes. Outside snap rings (OSR). Greaseable.
Use a caliper to measure every cap and BOTH joint axes. Compress the caps and measure the overall width across opposing cap end faces.
For the bearing, check the shaft bearing seat/bore and the actual mounting arrangement. Mounting centers are not overall bracket length; center height is measured to the mounting surface. Older catalogs show 1.520-inch bracket width; current Dana specification is 1.500 inches. Check clearance where critical.
Only the listed parts are included. This is not a complete driveshaft or CV rebuild kit; unlisted centering parts, yokes and separate installation hardware are not included. Verify modified shafts individually.
